FX 3D Deco Light Fighter Jet
FX 3D Deco Light Fighter Jet NEW!

FX 3D Deco Light Fighter Jet

$33.95

3DLightFX

Volume discounts

QuantityPriceYou Save
4 $31.40 Up to $10.19
8 $30.56 Up to $27.16

LED Lights How to install your 3D Crack Sticker 1. Unfold sticker and flatten creases. 2. Place sticker at desired location, place tape (painter's tape or similar) at the edge of the top of the sticker and mark arrows on tape and sticker for placement reference. 3. Carefully remove the back of the sticker. 4. Align arrows and carefully stick the top (top 1-2 inches) of the sticker to wall, make sure you hold the bottom portion away from wall. 5. Use a credit card or dull flat surface to slowly adhere the sticker, pressing against the paper backing, removing any air bubbles that may arise, remember to keep the bottom part of the sticker off the wall as you work your way down, out and towards the edges until the end. 6. Very slowly peel off the paper from the wall, making sure that the (fine edges) are stuck to wall. If any of the sticker peels up with the paper, simply put back against wall and press firmly with credit card until sticker adheres to wall. 7. Drill a hole in the spaces marked X and inset the wall plug, provided. Insert the screws provided to approximately ¾ of the way and place light onto screws. 8. Enjoy! How to remove your 3D Crack sticker without damaging your wall Warning! - Sticker removal should be done by an adult only.

No customer comments for the moment.

Write a review

FX 3D Deco Light Fighter Jet

FX 3D Deco Light Fighter Jet

Volume discounts

QuantityPriceYou Save
4 $31.40 Up to $10.19
8 $30.56 Up to $27.16

5 other products in the same category:

Cart 0 Shopping Cart

No products

Free shipping! Shipping
$0.00 Tax
$0.00 Total

Prices are tax included

Check out